Advertisement
Quick Links
Advertisement
Related Manuals for Triton ETA100
Summary of Contents for Triton ETA100
- Page 1 Mini Sliding Extension Table ETA100 Operating and Safety Instructions www.tritontools.com...
- Page 2 Thank you for purchasing this Triton product. These instructions contain information necessary for safe and effective operation of this product. Please read this manual to make sure you get the full benefit of its unique design. Keep this manual close to hand and ensure all users of this product have read and fully understand the instructions.
- Page 3 Fig. 1 11 13 Fig. 3 Fig. 2 Workcentre Fig. 4 Compact Saw Table Fig. 5 Router Stand Parts List...
- Page 4 Fig. 7 Fig. 6 Fig. 8 Compact Saw Table Fig. 9 Router Stand Parts List...
- Page 5 Fig. 12 Fig. 10 Fig. 11 Fig. 13 Fig. 14 Fig. 15 Fig. 16 Parts List...
- Page 6 Fig. 17 Fig. 19 Fig. 18 Fig. 20 Fig. 21 Fig. 23 Fig. 22 Parts List...
- Page 7 SAFETY INSTRUCTIONS WARNING. Read all instructions. Read all hard hat and hearing protection used in safety warnings and all instructions. Failure appropriate conditions will reduce personal to follow the warnings and instructions my result injuries. in electric shock, fire and/or serious injury. c.
- Page 8 NOTE: The tool must be used only for its prescribed repaired before use. Accidents are caused by poorly maintained power tools. purpose. Any use other than those mentioned in this manual will be considered a case of misuse. f. Keep cutting tools sharp and clean. Properly The user and not the manufacturer shall be liable maintained cutting tools with sharp cutting for any damage or injury resulting from such...
- Page 9 STEP 4 large round knobs to clamp. Slide the height stops up the leg slots until they touch the outer track Plug the two smaller Inner Bearings (6) into the and tighten into position. They help set the correct corner blocks below the low scale readings and height for future set ups, and serve as protection tighten using the Countersunk Screws (14) and against track slippage under heavy load.
- Page 10 end panel flanges. Use the brackets as a drill guide, necessary to unlock the latches and lift the table centre punching the hole positions toward the top clear to make these adjustments). of the slotted hole in the bracket. Drill 6.5mm or ⁄...
- Page 11 STEP 11C STEP 15C Fit the inner track to the left side of the Compact The last step is to fine-tune the inner track position (when viewed from the switch-box end) by locating in the horizontal plane, to ensure that the extension the brackets over the square tube, as shown in (Fig.
- Page 12 However when handling removing them entirely if required, at the front and/ very wide workpieces we recommend the Triton or rear. Loosely re-fit the bolts and nuts. Multi-Stands (Fig. 14) or have someone assist you to support the workpiece.
- Page 13 'hand-held' against a guide clamped to the Trenching, edge planing and shaping can be workpiece. performed in all modes of operation with a Triton Router Table, either fitted to a Workcentre or a Router Stand (model RSA300 only). Edge Planing For edge planing pieces up to 39"...
- Page 14 12 MONTHS from the (unless indicated otherwise) for information on future date of original purchase, Triton will repair, or releases. Details provided will not be made available to at its discretion replace, the faulty part free of any third party.
Need help?
Do you have a question about the ETA100 and is the answer not in the manual?
Questions and answers