1 Connecting The Drain Hose - LG WT1150C Series Owner's Manual

Hide thumbs Also See for WT1150C Series:
Table of Contents

Advertisement

Available languages

Available languages

CONNECTING THE DRAIN HOSE
y The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
flooding and property damage.
y The drain must be installed in accordance with any
applicable local codes and regulations.
y Make sure that the drain hose is not stretched,
pinched, crushed, or kinked.
OPTION 1: STANDPIPE
Bend the outlet end of the drain hose to form a U
shape. Insert the end of the drain hose into the drain.
If the drain is large enough for the flange on the hose
to fit inside, then do not insert the flange more than
1-2 inches into the drain. Use the tie strap included
with the installation materials in the foam block in
the tub to secure the drain hose to the drain.
If the water valves and drain are built into the wall,
39"
(99 cm)
Tie Strap
fasten the drain hose to one of the water hoses with
the tie strap (ribbed side on inside).
If your drain is a standpipe, fasten the drain hose to
the standpipe with the tie strap provided.
NOTE:
y Normal height of the end of the hose should be ap-
proximately 35"~47" (0.9~1.2 m) from the floor.
y Do not install the end of the drain hose lower than
29 in. (73.7 cm) or higher than 96 in. (243.8 cm)
above the bottom of the washer or more than 60
in. (152.4 cm) away from the washer.
y Never create an airtight seal between the hose
and the drain with tape or other means. If no air
gap is present, water can be siphoned out of the
tub resulting in poor wash/rinse performance or
clothing damage.
Drain Hose
39"
(99 cm)
Tie Strap
INSTALLATION INSTRUCTIONS
CAUTION
y Do not insert the end of the drain hose into the
standpipe more than 8 inches (20cm). Doing so
can cause siphoning, odors, or improper drain-
ing.
No more than 8 inches (20cm)
8"(20 cm)
Tie Strap
OPTION 2: LAUNDRY TUB
Bend the end of the drain hose to the desired shape
and support it on the edge of the laundry tub. Use
the tie strap to secure the drain hose in place.
NOTE:
y Do not use this drain hose with a floor drain. The
end of the drain hose must be at least 29 inches
above the floor for proper draining to occur.
11
Laundry Tub
Tie Strap
Drain Hose

Advertisement

Table of Contents
loading

Table of Contents