Connect The Gas Supply; Connect Electricity; Pump Controller - Rinnai Demand Duo H Series Installation And Operation Manual

Topics in this section

• Connect the Gas Supply

• Connect Electricity

• Pump Controller

WARNING
•
A licensed professional must install the gas
supply.
•
Turn off 120V power supply.
•
Turn off the gas.
•
Gas is flammable. Do not smoke or provide
other ignition sources while working with
gas.
•
Do not turn on the water heater or gas until
all fumes are gone.
Figure 45
Demand Duo™ H-Series Installation and Operation Manual
The gas swivel and gas
flex line can move in
multiple directions for
installation.
To connect the gas supply, follow the instructions
below:
1. Install a manual gas control valve in the gas
supply line to the water heater. A union can
be used on the connection above the shut off
valve for the future servicing or disconnection
of the water heater (Figure 45 on the follow-
ing page).
2. Check the type of gas and gas supply pres-
sure before connecting the water heater. If
the water heater is not of the gas type that
the building is supplied with, DO NOT con-
nect the water heater. Contact the dealer for
the proper water heater to match the gas
type.
3. Check the gas supply pressure immediately
upstream at a location provided by the gas
company. Supplied gas pressure must be
within the limits shown in the Section "3.2
Specifications" with all gas appliances oper-
ating.
Figure 46
3/4 in. MNPT Gas Connection
on Bottom of Water Heater
43