Kohler K-1109 Installation Manual page 2

Important Information
WARNING: When using electrical products, basic
precautions should always be followed, including
the following:
DANGER: Risk of electric shock. Connect only to a
circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI).
Building materials and wiring should be routed away from the
pump body and other heat-producing components of the unit.
Install to permit access for servicing.
Grounding is required. The unit should be installed by a
qualified service representative, and grounded.
Electrical Requirements
The installation must have a Class A Ground-Fault
Circuit-Interrupter (GFCI). The GFCI protects against
line-to-ground shock hazard. Use a 120 V, 15 A, 60 Hz
dedicated service for the whirlpool.
"H" models require a separate 120 V, 15 A, 60 Hz dedicated
service for the in-line heater.
NOTE: If the pump power cord is damaged, it must be
replaced with a service kit available by contacting the Kohler
Co.
Product Notices
WARNING: Unauthorized modification may cause
unsafe operation and poor performance of the
whirlpool. Do not relocate the whirlpool pump, or
make other modifications to the whirlpool system, as
this could adversely affect the performance and safe
operation of the whirlpool. Kohler Co. shall not be
liable under its warranty or otherwise for personal
injury or damage caused by any such unauthorized
modification.
C
1010997-2-
WARNING: Risk of electrical shock. A
licensed electrician should make all electrical
connections.
WARNING: Risk of electrical shock.
Disconnect power before servicing.
WARNING: Risk of injury or property
damage. Please read all instructions
thoroughly before beginning installation,
including the following requirements.
NOTICE: Follow all local plumbing and electrical
codes.
Factory-Assembled Features
Factory installed components include pump, air switch
transmitter, and power supply cord. No installation is
needed.
The whirlpool pump and piping are factory-assembled.
"H" models are also supplied with a factory assembled,
in-line heater.
Connections and Service Access
Before installation, ensure proper access to the final
connections.
NOTICE: Provide unrestricted service access to the
pump. You must provide access for servicing the
pump and controls. The access must be located
immediately next to the pump. Study the roughing-in
information packed with the whirlpool.
2
Kohler Co.