Checking The Oil Level; Activating The Battery - Toro DH 210 Setup Instructions

1. Snap ring
7. Secure a hinge pin on each side of the collector
(on the outside of the collector), with a snap ring
installed into the groove on the pin (Figure 4).
8. Slide the handle arm assembly into position, and
secure at the bottom of the grass collector dump
lever with a screw.
1
2
1. Grass collector dump lever 2. Screw
Note: You may need to adjust the switch activation
plate so that the switch operates properly.
1
B
A
A
G018123
Figure 4
2. Hinge pin
E
G018124
Figure 5
4

Checking the Oil Level

2
No Parts Required
Procedure
The machine comes from the factory with oil in the
engine crankcase; however, it may be necessary to add
oil. Refer to the Operator's Manual for oil type, viscosity,
and crankcase capacity. Add only enough oil to raise the
level to the Full mark on the dipstick.
5

Activating the Battery

No Parts Required
Procedure
1. Remove the battery from the machine; refer to the
Operator's Manual.
2. Remove the filler caps from the top of the battery.
DANGER
Battery electrolyte contains sulfuric acid that is
poisonous (if consumed) and can severely burn
you.
• Do not drink electrolyte.
• Avoid contact with skin, eyes, or clothing.
• Wear safety glasses to shield your eyes and
rubber gloves to protect your hands.
• Fill the battery where clean water is available
for flushing the skin.
• Follow all instructions and comply with all
safety messages on the electrolyte container.
3. Slowly pour electrolyte into each cell until the level is
up to the lower part of the tube.
4. Leave the filler caps off, and connect a 3- to 4-amp
battery charger to the battery posts.
5. Charge the battery at a rate of 2 amperes or less for
4 hours (12 volts).
Note: Do not overcharge the battery.
4