Step 2: Connect The Scanner - Visioneer OneTouch 7400 User Manual

12 V O
ISIONEER NE
T 7400 USB S
OUCH CANNER
S 2: C
TEP ONNECT THE
1. Remove any tape from the USB cable.
2. Using the steps on the screen as your guide, plug the square end of
the cable into the side of your scanner.
Plug into the Computer
3. Plug the flat, computer end of the USB cable into an available USB
port on the computer.
If the plug does not attach easily, make sure that you are plugging it
in correctly. Do not force the plug into either connection.
If you use a USB hub, it must have its own power supply already
plugged into an electrical outlet.
Note: Your scanner does not have a power switch. Plugging it in turns
on the power.
Your computer recognizes that a scanner has been plugged into the
USB port. If your computer is running Windows XP or Windows
Vista, you will see a Found New Hardware message similar to the
following.
I G
NSTALLATION UIDE
S
CANNER
Plug into the Scanner