Visioneer OneTouch 58XX Installation Manual page 12

8
V O
ISIONEER NE
T 58XX S I
OUCH CANNER
3. Click OK to close the dialog box.
That's it. Your scanner is ready to scan.
See "Three Ways to Scan" on page 10.
Note: The scanning lamp under the scanner's glass needs to warm up
before you can scan. A status message lets you know when the lamp is
ready. The lamp then remains ready so you don't have to wait for it to
warm up each time you want to scan. To conserve electricity and
prolong the life of the scanner, you can set the length of time for the
lamp to remain lit before powering down. See "Setting Preferences"
on page 22.
I S I
F THE CANNER S
If the scanner icon on the Windows taskbar has a red "X" through it,
the scanner is not properly connected.
Check for one of these possible problems:
•
Is a cable loose or not plugged in securely? Inspect all cable
connections. Make sure all the cables are plugged in securely.
•
Is the scanner's power light on? Turn on the scanner's power. If the
light still doesn't come on, plug the power adapter into another
electrical outlet.
•
Did you restart the computer after installing the software? If you
didn't restart the computer, it may not have loaded all of the software
files. Try restarting your computer.
Please see the Readme file in the PaperPort directory on your computer's
hard drive. The Readme file contains additional information that may
help you diagnose problems connecting the scanner. Also see
"Installation Troubleshooting" on page 35 of this Guide for more
information.
G
NSTALLATION UIDE
N P C
OT ROPERLY ONNECTED