Taking Your Blood Pressure Reading; Alert Symbol; Recalling Measurements In Memory - MABIS SmartSpeed 04-330-001 Instruction Manual

Taking Your Blood Pressure Reading

Proceed only after reading the previous sections of this manual.
Remember! Remain still; do not talk during the measurement.
1. Rest your elbow on a solid surface with your palm facing
upward. Elevate your arm so that the cuff is at the same level
as your heart, Fig. 1. Relax your left hand.
2. Press the POWER button. The unit will run a self-test, Fig. 2.
Fig. 2
3. The cuff will automatically begin to inflate, with varying
speeds of inflation.
4. The display will show the increasing pressure in the cuff,
Fig. 3.
5. Once the systolic pressure is reached, the cuff will exhaust
all air.
6. Your blood pressure (systolic and diastolic) measurement,
pulse rate and time will display, Fig. 4. See "Alert Symbol"
section if symbol appears.
7. Your reading will be automatically stored in memory.
8. To conserve energy, press the POWER button to turn the power off. Otherwise, the unit
will automatically shut off after approximately 1 minute.
9. Disconnect the cuff tubing from the monitor prior to storing.
Fig. 1
Fig. 4
.
– 10 –
Your monitor has a built-in Alert feature. If your blood pressure
exceeds 160 mmHg (SYS) or 95 mmHg (DIA), the Alert symbol will
display, Fig. 5.
This feature is an instant reminder to you and your physician of
measurements that may suggest hypertension.
You can recall up to 60 measurements in
memory to share with your physician or
trained healthcare professional.
1. Press the MEMORY button. The last
stored measurement will display.
Fig. 3
2. Continue to press MEMORY to
view the next previously stored
measurement.
NOTE: The memory bank can store up to
60 readings. When the number of readings
exceeds 60, the oldest data will be replaced
with the new record.
All stored measurements will be erased by removing any one of the batteries for
approximately 2 minutes.

Alert Symbol

Recalling Measurements in Memory

.
– 11 –
Fig. 5