Using The Watfmounted Door Control - Chamberlain Whisper Drive Security+ 248739 Owner's Manual

Hide thumbs Also See for Whisper Drive Security+ 248739:
Table of Contents

Advertisement

Using the Wa_Mounted Door Control
THE MULTI-FUNCTIONDOORCONTROL
Press the lighted push button to
open or close the door. Press again
to reverse the door during the
cIosing cycte or to stop the door
while it's opening.
Light feature
Press the Light button to turn the
opener light on or off. it will not
Push
Button
Lock
Button
Light
Button
control the opener lights when the door is in motion, if you
turn it on and then activate the opener, the light will remain
on ior 4-1/2 minutes. Press again to turn it off sooner. The
4-1/2 minute interval can be changed to 1-1/2, 2-112or
3q/2 minutes as follows: Press and hold the Lock button
untii the light blinks (about 10 seconds). A single blink
indicates that the timer is reset to 1-1/2 minutes. Repeat
the procedure and the light wi!l blink twice, resetting the
timer to 2-t/2 minutes. Repeatagain for a 3-1/2 minute
interval, etc., up to a maximum of four blinks and 4-1/2
minutes.
Lock feature
Designed to prevent operation of the door from hand*
held remote controls. However, the door will open and
close from the Door Control, the Outside Keylock and the
Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds.
The push button light will flash as long as the Lock feature
is on_
To turn otL press and hold the Lock button again for
2 seconds. The push button light will stop flashing. The
Lock feature will also turn off whenever the "iearn" button
on the motor unit panel is activated.
Additional feature when used with the 3-Button
hand-heN remote
To control the opener lights:
In addition to operating the door, you may program the
remote to operate the Iights.
1. With the door closed, press and
.._
hold a small remote button that
you want to control the light.
2. Press and hold the Light button
on the door control.
3. While hotding the Light button, press and hold the Lock
button on the door control.
4. After the opener lights flash, reiease all buttons.
ToOpen the DoorManually
To prevent possible SERIOUSINJURY or DEATHfrom
a ialling garage door:
If possible, use emergency release handle to
disengage trolley ONLY when garage door is
CLOSED.Weak or broken springs or unbalanced
door could resutt in an open door falling rapidly
and/or unexpectedly.
NEVERuse emergency release handteunless
garage doorway is clear of persons and
obstructions.
°
NEVERuse handle to puI[ door open or closed. If
rope knot becomes untied, you could fall.
DISCONNECT
THE
TROLLEY:
The door should befully closed
if possible, Pull down on the
emergency release handfe(so
that the trolley refeasearm
snaps into a vertical position)
and lift the door manually.
The lOckOutfeature prevents
the trolley from reconnecting
automatically, and the door can
be raised and iowered manually
as often as necessary.
Trolley
Release Arm\ /
(tnMannai H
Disconnect
Position)
LOCKOUT POSITION
(MANUAL DISCONNECT)
TO RE-CONNECT T HE TROLLEY:
Pull the emergency reiease
handle toward the opener at
an angle so that the troIIey
release arm is horizontal.
The tro[Iey will reconnect
on the nexl UP or DOWN
operation, either manually or
by using the door control or
remote.
TrolJey
e
Emergency
__
Reiease Handle '_
(Downand8ack)_'
TO RECONNECT
33

Advertisement

Table of Contents
loading

Table of Contents