Changing The Coding - Westfalia Wetecom 99 67 36 Instruction Manual

Code Correspondence between remote control and wireless socket.
Switch settings 1 – 4 of the socket comply with the coding of the
ON/OFF buttons 1 – 4 on the remote control.
DIP switches A – F on the remote control comply with the coding of
the sockets F – A.

Changing the Coding

Please note that this remote control set operate in a frequency band
also used by many other wireless applications. If you want to
change the coding of your remote control set, due to interferences
from other remote control units in your neighbourhood that uninten-
tionally switch on your appliances, proceed as follows:
1. Disconnect the wireless sockets from power mains.
2. Unscrew the cover from the wireless sockets and open the
battery compartment lid of the remote control.
3. Change the receive channels according to the below mentioned
drawing. To change the factory-made coding, slide one or
several DIP switches upwards. Please observe the below hints:
Operating
A B C D E F
17
F E D C B A