Arming While Driving; Disarming - Viper 671XV Owner's Manual

Viper owner's guide vehicle security system 671xv

Table of Contents

After each press of the

remote will emit normal arm notification (1 beep and 3 flashes

of the Orange LED). For easiest operation in reaching each level

of security, press

arming while driving

Your security system can be armed while driving the vehicle! Simply

press

on the 2-way remote for two seconds while the vehicle is

running. The siren will chirp once to indicate that the security

system is armed, and then once more to indicate that the ignition is

on. The system will not respond to any input except the door trig-

gers, and the starter kill relay (if installed) will not be activated. Once

you have arrived at your destination, the system can be disarmed by

pressing the

twice and the in-vehicle status LED will then stop flashing. The

system can also be disarmed at any time by pressing

The remote will respond with the normal arming response plus a

diagnostic notification because the ignition On. When disarmed

the remote will respond with the normal disarming response.

To disarm the security system, press

chirps, and the parking lights will flash twice. If the power locks

are controlled by the system, the doors will also unlock. The

siren chirping either four or five times when disarming indicates

Tamper Alert, which is described in the Diagnostics Section of

this guide.

to reach the next level of security, the

immediately a a f f t t e e r r each notification.

or by turning the ignition Off. The siren will chirp

. .

. You will hear two

Table of Contents