Advertisement
4. Install remaining electrical connections to PCB.
B. INSTALLATION OF EXTENSION HARNESS, J2
Note: Depending on the lift application, the J2 connector harness may or may not need to be extended. If upon
installing PCB assembly RI55664 the harness does not reach connector J2, proceed with section B. Otherwise,
continue to section C.
1. Locate harness connector that mates with J2 and cut wires at end of connector. Refer to Figures 6A-6B. Strip
the wire ends as necessary.
2. Splice in extension harness RI55913. Connect the extended harness to J2 on the PCB. Refer to Figures 7A-
7B.
08/10/14
FIGURE 5: NEW TERMINAL ORIENTATION
FIGURES 6A/6B: REMOVAL OF HARNESS CONNECTOR, J2
32II470e.B
4 of 5
Advertisement
