Advertisement
III.
INTRODUCTION
The purpose of this document is to outline the step by step procedure for the installation of Kit #55914 for PCB
RI55664 and Extension Harness RI55913 (if needed) for the S/K Series Lifts. Follow all safety precautions before
attempting to perform installation or maintenance of the S/K Series Lift. Remove power to vehicle and/or turn off
ignition. Remove the power cable from the S/K Series Lift.
A. REMOVAL OF FACTORY PCB
Note: The Pump assembly may or may not need to be removed depending on the lift configuration (Left hand or Right
hand side) and location of PCB. If removal is unnecessary, skip to step 3 below.
1. Remove the pump cover, making sure to unplug the warning light if installed, and set aside.
2. Unbolt the pump assembly; pull and tie away from the lift for optimum working area. Removal of the hydraulic
lines and/or electrical connections may be necessary.
3. Important! Locate factory PCB. Remove electrical connections from PCB, making sure to make a note or
mark the connections for terminals T1-T4 for ease of identification and installation later.
4. Remove the factory PCB assembly from the lift.
5. Remove the factory PCB from the PCB mounting plate.
6. Install PCB RI55664 onto the PCB mounting plate.
IV.
INSTALLATION OF KIT #55914
A. INSTALLATION OF PCB ASSEMBLY
Note: PCB RI55664 is sent configured from the manufacturer with jumpers in the following locations; J9, J14.
1. Configure the jumpers on PCB RI55664 for the lift application. Remove jumpers as needed.
Refer to Figure 1.
2. Install the PCB assembly on the lift.
3. Install TWS sensor sets to PCB, ensuring TWS sensors sets are properly connected. Refer to Figures 2-3.
08/10/14
If Replacing
33461
33057
55809
47388
55664
FIGURE 1: PCB RI55664 JUMPER CONFIGURATION MATRIX
TWS Sensor Set #
1
2
3 (If applicable)
FIGURE 2: PCB RI55664 TWS SENSOR SET LOCATIONS
Leave
Remove
J9, J14
N/A
J14
J9
J9
J14
J9
J14
J9
J14
Sensor Set Location
J4, J5
J6, J7
J13, J14
32II470e.B
2 of 5
Advertisement
