Page 1
Optelecom 9000 Series Installation and Operation Manual Model 9421DT Model 9421DR Rack-Mounted Fiber Optic Video Transmitter and Receiver Cards For transporting two NTSC or PAL, or SECAM video signals, two duplex user-selectable Option Module port signals, and a high-speed duplex RS422 data port signal over one optical fiber.
Table of Contents Section Page Safety Instructions Instrucciones de Seguridad Sicherheitsanleitungen Consignes de Sécurité Fiber Information External Wiring Information Functional Description 9421DT Indicator and Connector Locations 9421DR Indicator and Connector Locations Set Up and Operation of the 9421D Typical Application of the 9421D Operation of the 9421D with the Network Management System Software Troubleshooting 9421D Links Specifications for the Model 9421D...
Failure to comply with any precaution, warning, or instruction noted in the manual is in violation of the standards of design, manufacture, and intended use of the unit. TKH Security Solutions USA assumes no liability for the customer’s failure to comply with any of these safety requirements.
Si no se cumple con alguna precaución, advertencia o instrucción indicada en este manual se infringen los estándares de diseño, fabricación y el uso destinado a la unidad. TKH Security Solutions USA no asume ninguna responsabilidad si el cliente no cumple con alguno de estos reequisitos de seguridad.
Einheit betrieben, gewartet oder repariert wird. Falls Vorsichtsmassnahmen, Warnungen oder Anweisungen in diesem Handbuch nicht befolgt werden, verstösst dies gegen die Konstruktions, und Herstellungsstandards und erfolgt im gegensatz zum vorgesehenen Verwendungszweck dieser Einheit. TKH Security Solutions USA übernimmt keine Haftung für das Verabsäumnis des Kunden, diese Sicherheitsanforderungen einzuhalten.
Le non-respect d’une précaution, d’un avertissement ou d’une instruction figurant dans ce manuel est une violation des normes de conception, fabrication et indication d’usage de l’appareil. TKH Security Solutions USA n’est pas responsable du non-respect de ces consignes de sécurité par le client.
Fiber Information This unit was manufactured with attention to fiber cleanliness by TKH Security Solutions USA. Beyond the optical safety information contained in this manual, the following guidelines should be observed when working with optical fibers. The biggest problem is dirt! It takes very little contamination to cause problems with optical fiber connections;...
The 9421DT and DR support two TKH Security USA Data/Audio Option Modules. The modules operate bidirectionally. The user may select from duplex audio (Option Module type A), duplex data (Option Module type B), duplex contact closure (Option Module type C) or Stereo Audio (Option Module type D, Stereo Input, and E, Stereo Output).
9421DT Indicator and Connector Locations IGURE 1. SYNC INDICATOR This multicolor LED provides status information about the link as follows: indicates no power is applied to the card. (No Sync) indicates the local unit is not receiving sufficient optical signal from the remote unit or the local demux circuitry is not able to synchronize to the incoming signal.
Page 11
5. AUX I/O 1 CONNECTOR This is the connector for Option Module position 1. Refer to the separate Option Module Manual included with your shipment for details on connections to the Option Modules. 6. AUX I/O 2 CONNECTOR This is the connector for Option Module position 2. Refer to the separate Option Module Manual included with your shipment for details on connections to the Option Modules.
9421DR Indicator and Connector Locations IGURE 1. SYNC INDICATOR This multicolor LED provides status information about the link as follows: indicates no power is applied to the card. (No Sync) indicates the local unit is not receiving sufficient optical signal from the remote unit or the local demux circuitry is not able to synchronize to the incoming signal.
Page 13
AUX I/O 1 CONNECTOR This is the connector for Option Module position 1. Refer to the separate Option Module Manual included with your shipment for details on connections to the Option Modules. AUX I/O 2 CONNECTOR This is the connector for Option Module position 2. Refer to the separate Option Module Manual included with your shipment for details on connections to the Option Modules.
ORTS PERATION Aux Ports 1 and 2 are supported by TKH Security USA Option Modules. These may be duplex audio, data, contact closure, or stereo audio depending on how the cards were ordered from the factory. The user can exchange Option Module types as required, contact your local TKH Security USA representative or the factory for details on changing Option Module types.
Page 15
IGURE TABLE 1 — 9421DT AND DR HIGH-SPEED PORT CONNECTIONS RJ45 Pin # Signal Name Tx Data (+) Input Tx Data (–) Input Tx Clock (+) Output Rx Data (+) Output Rx Data (–) Output Tx Clock (–) Output Rx Clock (+) Output Rx Clock (–) Output...
Typical Application of the 9421D Operation of the 9421D with the Network Management System Software Operation of the 9421D with the Network Management System consists of the following parameters: 1. Card Location 2. Card Size 3. Card Name (Model Number) 4.
Troubleshooting 9421D Links The indicator LEDs on the transmitter and receiver provide information as to the optical and electrical status of the units. Troubleshooting normally starts at the transmitting end. On the 9421DT and 9421DR cards, the sync indicator should be illuminated with one of three colors. If it is not illuminated, check the chassis power supply, power source, and connections.
Specifications for the Model 9421D OPTICAL SPECIFICATIONS Model Fiber Size 50/125 62.5/125 09/125 Tx Optical Output Power (dBm) –11 –7 –7 Tx Output Wavelength 1310 1310 1310 Rx Receiver Sensitivity (dB) –29 –29 –25 Tx Budget (dB) Rx Optical Output Power (dBm) –11 –7 –7...
Page 19
Dimensions (in inches) 6.1 H x 0.8 W x 8.6 D ENVIRONMENTAL Operating Temperature -40° C to +74° C Storage Temperature -55° C to +85° C Relative Humidity 0 to 95% noncondensing MECHANICAL MOUNTING AND CONNECTIONS DIMENSIONS...
Need help?
Do you have a question about the Optelecom 9000 Series and is the answer not in the manual?
Questions and answers