TKH Siqura VBS 2010 TX User Manual

1. General description
The VBS 2010 TX analogue optical video baseband
transmitter converts a composite video signal into
an optical equivalent. Signal integrity is preserved
with the aid of video clamping.
The VBS 2010 TX utilises an optical wavelength of
850 nm and needs multimode optical fiber.
The 7TE modules are to be used in combination
with TKH Security's MC 10 or MC 11 power
supply cabinets.
Using TKH Security's ADV units, the signal
transmitted by these plug-in modules can in
addition to video comprise two data signals, still
using only one optical fiber.
2. Indicators and connectors
Figure 1 shows the signal connection facilities and
indicators on the front panel of a VBS 2010 TX
single-channel transmitter (see also table 1).
o

o
(ST connector)


(75 BNC connector)
Status indicator LEDs
* DC (green)
* NV (red)
Table 1. Front panel indications and connectors on the
VBS 2010 TX
3. Installation instructions
1. Plug the module into a power cabinet and
connect optical fiber
equipment to the module: optical cord to the output
and video lead to the input (figure 1 and table 1).
2. After switching on the cabinet, at least the green
DC LED must glow.
3. On feeding the TX video input with a proper
signal, the NV LED (red) should go out.
© Siqura 2017
Version 992112-2f
VBS2010TX (MW10)
VBS 2010 TX
Optical video baseband transmitter
USER MANUAL
optical output
video input
DC power supply
No video at input
equipment and video
VBS
DC
NV
Figure 1.
Front panel layout of VBS 2010 TX
transmitters
4. Care and maintenance
In order to maintain reliable operation of the
module, observe the following:
- Prevent dust from collecting on the equipment
- Protect the equipment against moisture
- Maintain sufficient free space around the equip-
ment for cooling.
General safety and EMC information is found in the
final section of this document.
TX