Summary of Contents for Precision Flight Controls CAT I
Page 1
P r e c i s i o n F l i g h t C o n t r o l s , I n c . S e r i a l C A T I S y s t e m a n d X - P l a n 9 S e t u p G u i d e...
Page 2
Getting the COM Port information: The COM port or serial port is a port used by the CAT I System to communicate to X-Plane. It is important to know the correct COM port number that your CAT I System is connected to, as this information will be necessary for proper communication and operation between X-Plane and CAT I System.
Page 3
25. Now turn and hold your yoke all the way to the RIGHT and click on Set RIGHT on ROLL 26. Center the yoke now and click on SET CENTER on ROLL Serial CAT I and X-plane 9 Setup Guide P a g e...
Page 4
32. Now make sure that the Rudder Trim is Centered and click on Set Center on RUD TRIM If you do not have Precision Flight Controls Cirrus Pedals please skip this step. Please also go back to Step 13 and Disable the PFC Serial Port Rudder Pedals.
Need help?
Do you have a question about the CAT I and is the answer not in the manual?
Questions and answers