Advertisement
Quick Links
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable
components,
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
such
as
rubber
deluxe bath bench
EU Authorized Representative
Drive Medical LTD
Ainley's Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP
www.drivemedical.com
Advertisement
Related Manuals for Drive Medical 12203kd4
Summary of Contents for Drive Medical 12203kd4
- Page 1 If you have a question about your Drive device or this warranty, please contact an authorized Drive dealer. EU Authorized Representative Drive Medical LTD Ainley’s Industrial Estate Elland, West Yorkshire, United Kingdom HX5 9JP www.drivemedical.com ©...
- Page 2 assembly instructions additional precautions Inspect all parts for shipping damage before Remove contents from box. assembly. If there is shipping damage - DO Lay seat upside down on a flat surface so the 4 leg NOT USE. Contact dealer/carrier for further receptacles are facing upward. instructions. 3. Insert first leg into the leg receptacle by depressing 2. Make certain that the height adjusting snap push pin. When the leg is in place, the brass push buttons fully protrude through the same pin will extend out and lock the leg in place respective hole of each leg extension. This (Figure 1). will ensure that the leg extensions are 4. Repeat Step 3 for the remaining 3 legs. securely locked in position and an even height is achieved. 3. Ensure ALL screws, nuts and/or bolts are tightened. 4. Check the rubber tips on the leg extensions for rips, wear or if they are missing. Immediately replace any or all if any of these imperfections exist. 5. All four leg extensions with rubber tips MUST touch the floor simultaneously at all times. 6. DO NOT stand on chair. NOTE: To maintain the beauty of the original finish, figure 1 clean with mild soap and rinse with warm water. Wipe...
Need help?
Do you have a question about the 12203kd4 and is the answer not in the manual?
Questions and answers