Advertisement
FOOTSWITCH (MIDI IN) (13) This 8-pin DIN jack is used to connect the included hand controller or any
compatible 5/7-pin interfaced MIDI switching device. Details on the hand controller functions are found in a
separate section below.
STEREO EFFECTS LOOP (14) In MONO mode (only LEFT/MONO SPEAKER connected), this is a standard
mono post EQ effects loop where the LEFT and RIGHT loops can both be used, but will sum the effects to a
mono signal before being routed to the power amp. It is remote selectable (via MIDI or supplied hand control-
ler), used for patching effects into the signal chain. In STEREO mode (two speakers connected), the LEFT and
RIGHT loops are sent to the power amp as true stereo effects. High quality shielded instrument cables should be
used from the SEND and to the RETURN in all cases.
STEREO MSDI SECTION(15) These jacks provide a microphone-simulated direct out signal to a mixing con-
sole or recording device. With no speakers connected, the output will be brighter, as these signals are tapped
directly from the SPEAKER OUTPUTS. The speakers being used define the high frequency characteristics, as if
they were mic' d up. A GROUND LIFT switch is provided for each to minimize AC line interference, as needed.
SPEAKER OUTPUTS (16) These jacks provide a direct connection to any desired speaker cabinet with a nom-
inal impedance of 4 Ohms, or greater. When using only one cabinet, connect to the LEFT/MONO jack. Use
BOTH jacks for Stereo operation, only.
Note: When both speaker jacks are used, the SPRING REVERB, DIGITAL EFFECTS SECTION, STEREO EF-
FECTS LOOP, and MSDI are automatically split into stereo operation. When only the LEFT/MONO SPEAKER
is connected, these are all summed to a mono signal, in the same manner.
FUSE (17) Always replace the AC MAINS FUSE with the same size and type specified, per voltage version.
WARNING! NEVER ATTEMPT TO REMOVE THE FUSE CAP OR REPLACE THE FUSE UNLESS THE
POWER CORD HAS BEEN DISCONNECTED FROM THE POWER OUTLET.
IEC INLET (18) Used to connect the appropriate line cord (supplied), per voltage version.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have
a ground pin, a suitable grounding adapter should be used, and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always make sure that the amplifier and all associated equipment is prop-
erly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be
connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored green or green and
yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N, or
the color black. (3) The wire that is colored brown must be connected to the terminal that is marked with the
letter L, or the color red.
Advertisement
