Installation; Permanently Mount The Pim400-1501 - Schlage PIM400-1501 User Manual

Installation

1. If linking was successful, install the PIM400-1501. Install and link additional WAPMs.
2. If linking was unsuccessful, move the PIM400-1501 six to ten inches in any convenient
direction and repeat steps 4 through 6 of the Pre-Installation Test (see page 6) until all
WAPMs link successfully. If linking is still unsuccessful, move the PIM400-1501 closer to
the WAPM(s) and repeat, or add more PIM400-1501 modules.
If still not linking successfully, RF interference may be the cause. Refer to the SUS
L
user guide for information on changing the RF channel, and/or consider using a
remote antenna module (ANT400).

Permanently mount the PIM400-1501

Follow these steps to permanently mount the PIM400-1501 to its desired location.
1. Place the PIM400-1501, cover removed, against the wall in the position where it successfully
linked.
2. Orient the PIM400-1501 vertically with the radio board at the top of the enclosure.
3. Drill four holes, >\cx" diameter drill bit, 1C\v" deep, located to match the mounting holes as
shown on page 3.
4. If the location does not adequately support the PIM400-1501, wall anchors should be
used (not included).
5. If mounted on a non-metallic surface or where no metal is within 1 inch (25 mm) of the
back of the PIM400-1501, attach the PIM400-1501 directly to the wall using appropriate
#8 mounting hardware.
6. If mounted on a metallic surface or where metal is within 1 inch (25 mm) of the back of
the PIM400-1501, attach the PIM400-1501 1 inch (25 mm) from the wall.
If a remote antenna is to be used, refer to the optional remote antenna module
L
(ANT400) user guide.
7 • Schlage • PIM400-1501 user guide