Amplifier System Protection Operation Specification - Pioneer VSX-D714-K Service Manual

1

7.3.4 AMPLIFIER SYSTEM PROTECTION OPERATION SPECIFICATION

QQ
3 7 63 1515 0
1. DC-abnormality detection
A
If there is a fault in the power amplifier or a high-level signal lower than 5 Hz is input,
the DC_DET port becomes "L".
If the "L" is detected, the microprocessor will perform as following flow chart.
In the case of simultaneous detection with the overload protection circuit,
DC-abnormality detection is performed preferentially to overload detection.
When a DC abnormality is detected, A.MUTE* is turned
B
The abnormality continues for 3 seconds.
The power is shut off.
The power key is disabled and Standby LED blinks.
But be switched on with the following methods.
1 TESTMODE ON (A55F+A55F)
C
2 When power off, push FRONT ENTER key + ADVANCED SURROUND key continuously 2sec.
(2: When a DC abnormality is detected and the power is shut off.)
TE
L 13942296513
2. Overload detection
If the speaker terminals are short-circuited or low-load driving is detected, the OL_DET port becomes "L".
If the "L" is detected, the microprocessor will perform as following flow chart.
When an overload is detected, A.MUTE* is turned on,
D
"OVERLOAD" flashes on the display.
The abnormality continues for 3 seconds.
The power is shut off.
E
www
F
74
1
http://www.xiaoyu163.com
2
on, speaker relay is turned off, then
"AMP_ERR" flashes on the display.
↓
↓ Continues.
↓
speaker relay is turned off, then
↓
↓ Continues.
x ao
y
. i
VSX-D714-K
2
http://www.xiaoyu163.com
3
8
*A.MUTE : Audio mute command
The program restarts.
Q Q
3 6 7 1 3
The power is shut off even if the
unit recovers.
u163
.
3
4
2 9 9 4 2 8
↓ Recovery
1 5 0 5 8 2 9 9 4
↓ Recovery
m
co
4
9 9
2 8 9 9