Installing Drive Rolls - Lincoln Electric PIPEFAB Series Operator's Manual

PIPEFAB™ WELDING SYSTEM INSTALLATION

INSTALLING DRIVE ROLLS

FIGURE A.7
1. Turn power OFF at the welding power source.
2. Open the wire drive door by pulling on the top.
3. Remove the outer wire guide.
4. Remove drive rolls by pulling straight out. It may be necessary to wiggle the drive roll to free it from
the snap ring.
5. Remove the inner wire guide.
6. Install the new inner wire guide, with the arrow poin�ng in the direc�on of wire travel.
7. Install the drive rolls and outer wire guide.
8. Close the wire drive door and adjust the pressure se�ng accordingly.
A-7