Charging Reader - Biomark HPR LITE READER User Manual

The reader is connected to the AC power supply or USB port of a PC.
•
The reader is connected to a PC via Bluetooth in slave mode (remote device has
•
established the connection). The reader will power off automatically after 60 minutes of
inactivity.

2.2 Charging Reader

The reader has an internal 7.2V lithium ion re-chargeable battery.
To charge the battery, follow these steps:
• Fast Charge: Plug the Micro USB cable into the connector at the bottom of the reader,
then plug the USB connector into the AC power supply. Charging using this method will
take <6 hours with a healthy battery.
with the reader, please ensure you are using the correct adapter for your location.
• Slow Charge: Plug the Micro USB connector of the cable into the connector at the
bottom of the reader, then plug the USB connector into a USB port of a PC. Charging
using this method will take ≤16 hours with a healthy battery.
Note: Water cannot enter the reader through the connector, but any moisture could damage the
terminals in the Micro USB cable if inserted while wet.
Ambient temperature during battery charging must be between 0°C (+32°F) and +40°C
(+104°F) with relative humidity between 35% and 85%, non-condensing.
The HPR Lite reader is not intended to be operated while the battery is charging. Should the
reader begin scanning while charging, the charge will be suspended and will restart after the
scanning operation is finished.
Please be aware that when using the reader in environments below freezing temperature, the
battery's ability to supply power will be reduced. This will reduce the reader's battery run-time
and possibly the maximum usable RF transmit power resulting in reduced reader performance.
Please ensure your reader is set to use power saving mode under these conditions to avoid
excessively loading the battery. See page 15, section 3.1 for more details.
Warning! Do not try to access or replace the internal battery. Contact Biomark for battery
replacement. Risk of fire if the battery is replaced by an incorrect type.
HPR Lite User Manual
Multiple power plug adapters have been provided
8