Getting Started; Turning Reader On And Off - Biomark HPR LITE READER User Manual

2. Getting Started

2.1 Turning Reader On and Off

The reader can be powered on by any of the following methods:
Pressing and holding the OK button for 1 second.
•
Connecting the reader to the included AC power supply or USB port of a PC.
•
Upon powering up, the reader will display a splash screen and emit a short beep. This screen
will display the present firmware version in the bottom right corner. After approximately 1.5
seconds, the reader will display the main screen.
Screen During Power Up
Note: Operating ambient temperature of the HPR Lite reader must be between -20°C (-4°F) and
+58°C (+136.4°F) with relative humidity between 10% and 90%, non-condensing.
The reader can be powered off by any of the following methods:
• Pressing and holding the OK button while in main screen. After approximately one
second a shutdown timer will appear. Continue holding the OK button until the reader
sounds two beeps and shuts down. The countdown can be aborted by releasing the OK
button.
• The reader will automatically power off after a certain period of inactivity. The inactivity
time is user adjustable and by default is set to 180 seconds (3 minutes). Pressing any
button will reset the timer.
The reader will stay powered on while:
HPR Lite User Manual
Main Screen
7