Maintenance; Warranty - GCE X11 ORIGINAL i Instructions For Use Manual

valve (3) little bit more.
10. Light the gas mixture in front of the nozzle .
11.
Open the cutting-oxygen by pressing the lever or opening cutting oxygen
valve (14). Adjust the oxygen pressure by means of the adjusting screw on the
regulator or the supply point.
12.
Once the cutting oxygen is flowing, the heating flames can be adjusted by
means of the fuel-gas valve (3) and the heating oxygen valve (13)
13.
The device is now ready for use.
5.3. EXTINGUISHING THE FLAME
1. Release the lever of the valve or closed the cutting oxygen valve for the cutting
oxygen (14).*
2. Slowly close the valve for fuel gas (3) and after that valve for heating oxygen (4).
3. Closed the valve for heating oxygen (13) on the cutting attachment. *
*(Cutting set only)
6.

MAINTENANCE

Keep the torch clean. Do not lubricate any of the parts. Oil or grease can cause an
explosion when in contact with oxygen.
• The holes in the cutting nozzle should be cleaned when necessary with appro-
priate cleaning needles or with KR21 chemical cleaner. Do not use drill bits, steel
wire or similar objects for cleaning, as the channels inside the nozzle will be
damaged.
• Proper flames and an even flow of cutting oxygen cannot be obtained unless
the edges of the nozzle holes are sharp.
• If the outlet end of the welding or cutting nozzle is damaged, it may be repaired
by polishing perpendicularly with a fine emery cloth laid on a flat surface.
• If a valve turns too easily or too stiffly, tighten or loosen respectively the packing
nut with the spanner supplied. Obtain help from a service engineer if repairs
are necessary.
6.1.REPAIRS
Repairs must be done by authorized personnel only.
7.
LIFETIME
Life time of the product is 10 years.
8.

WARRANTY

The Standard Warranty period is two years from date of receipt by the GCE Customer
(or if this is not known 2 years from time of the product manufacture shown on the
product).
The standard warranty is only valid for products handled according to Instruction for
use (IFU) and general industry good practice and standards.
APPENDIX:
Nr.1 - Cutting table
19/68
MANUFACTURER:
GCE s.r.o.
EN