GE Current Evolve Installation Manual

Evolve Field Adjustable
™
Module
(FAM)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for future use.
Risk of electrical shock. Disconnect power before service
installation, or maintenance of the product.
Risk of injury. Wear safety glasses and gloves during
installation and servicing.
GENERAL
The Field Adjustable Module (FAM) is a factory-installed
voltage regulating device that is connected to the gray
(-) and violet (+) 0-10V dimming leads of the LED driver.
Manually dialing the switch allows the fixture to be
dimmed in the field.
Dimming Voltage
+ -
Position ( 0.1V)
10 OPEN
9 OPEN
8 7.75
7 6.59
6 6.06
5 5.50
4 4.71
3 4.49
2 3.02
1 3.01
All trademarks are the property of their respective owners. Information provided is subject to
change without notice. All values are design or typical values when measured under laboratory
conditions. Current, powered by GE is a business of the General Electric Company.
© 2018 GE.
www.currentbyge.com
WARNING
CAUTION
% Output
+ -
Power ( 5%)
100%
100%
85%
71%
64%
58%
49%
47%
31%
30%
GEH6073-EN (Rev 12/26/18)
1
ADJUSTING THE OUTPUT
Rotate the actuator knob by hand or with a flat head
screwdriver to adjust the light output based on the table.
Position 10 is the factory default position and represents
full brightness. Position 1 is the lowest brightness level.
Fixture % lumen output is
approximately equal to %
output power.
Actual Lumens = Rated Lumens x
% Output Power
Example:
Rated Lumens = 15,000 lm
FAM Position = 7
% Output Power = 71%
Actual Lumens = 10,650 lm
Note: Specifications subject to change
without notice. Actual performance may
vary with application conditions.
Circuit is protected up to 30V.
FAM is not compatible with DALI
control or GE Light Grid.
Installation Guide
GEH-6073