1.8 x 1.2 (6' x 4') overlap shiplap & loglap sheds (4 pages)
Summary of Contents for Rowlinson Arley Summerhouse
Page 1
Arley Summerhouse English SS191A Assembly Instructions Before assembly • We recommend that time is taken to read the instructions before starting assembly, then follow the easy step by step guide. The instruction sheet is only a guide to the assembly. Certain items may not be shown to scale.
Page 2
If the building is to sit on soil or grass it MUST be erected on pressure treated wooden 50mm x 50mm or similar bearers (These are not supplied in the kit). Rowlinson Garden Products recommend using pressure treated bearers with all build- ings on any type of base.
Page 3
4. Apex panels Place an apex panel on top of the back wall, make sure the bottom shiplap board of the apex panel fits correctly into the shiplap board of the back wall. Secure using 2 x 50mm screws, screw up through the top frame of the back wall into the bottom frame of the apex panel. Fit the front apex in the same way using 2 x 60mm screws. Attach to the front apex the door frame beading using 3 x 25mm nails.
Page 4
8. Verandah Lay the verandah floor butted centrally up against the front of the building. Position a verandah fence at each end with the fence frames sitting on the verandah floor and the railings overhanging the floor edge. Secure the fence to the front of the building using 3 x 50mm screws. Use 3 x 50mm screws to attach each fence to the floor. Fix a v eran- dah roof support to the end of each fence using 3 x 50mm screws per support, ensure the angled end of the support is at the top and is angled in the same direction as the roof.
Page 5
10. Roofing felt Cut the 6m roofing felt roll into two equal lengths. Place a length over half of the roof. At the front and along the lower edge of the roof leave an overhang of felt of at least 45mm.
Page 6
If the building is to sit on or grass it MUST be erected on pressure treated wooden 50mm x 50mm or similar bearers (These are not supplied in the kit). Rowlinson Garden Products recommend using pressure treated bearers with all buildings on any type of base.
Need help?
Do you have a question about the Arley Summerhouse and is the answer not in the manual?
Questions and answers