With kind regards Your Beurer team Why use a daylight therapy lamp? Intended Use The intended use of the Light Therapy Lamp is to provide light source to offer a kind of “Light therapy” function in which the artificial light environment would provide end user with sense of relax or help them to ease depression, or treat seasonal affective disorder.
2. Signs and symbols The following symbols appear in these instructions or on the device. Read the instructions of use Permissible operating temperature Operating and humidity Warning instruction indicating a risk of Note on important information injury or damage to health. Note Warning Safety note indicating possible damage to...
• Danger of strangulation due to excessively long cables. • Protect the unit from strong impacts. • Do not pull the mains part out of the socket using the mains cable. • If the mains part or its housing is damaged, this must be replaced by customer services or the retailer, as a special tool is needed for repair.
„-“ button until the LEDs go out. Brightness adjustment The daylight therapy lamp TL 70 has 10 brightness levels. The desired brightness level can be set using the „+/-“ buttons on the side – this level should be set so that it is pleasant for the eye during the treatment.
Enjoying the light Sit as close as possible to the lamp, between 10 cm and 40 cm. You can go about your normal activities while using it. You can read, write, make telephone calls, etc. • Every so often, briefly look directly into the light, since the effect results from the eyes/ retina receiving the light.
MP45 – 240150 – AG Model no. Input 100–240 V ~ 50/60 Hz Output 24 V DC, 1.5A, only in connection with TL 70 Protection The device is double protected and therefore corresponds to protection class 2, protection class II...
During the warranty period, should this product prove to be incomplete or defective in functionality in accor- dance with the following provisions, Beurer shall carry out a repair or a replacement delivery free of charge, in accordance with these warranty conditions.
Page 9
Table 1: Declaration - electromagnetic emissions Guidance and manufacturer’s declaration - electromagnetic emissions The model TL 70 is intended for use in the electromagnetic environment specified below. The customer or the user should assure that it is used in such an environment.
Page 10
Table 1: Declaration - electromagnetic emissions Guidance and manufacturer’s declaration – electromagnetic immunity The TL 70 is intended for use in the electromagnetic environment specified below. The customer or the user should assure that it is used in such an environment.
Page 11
If the measured field strength in the location in which the model TL 70 is used exceeds the applicable RF compliance level above, the model TL 70 should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as reorienting or relocating the model TL 70.
Page 12
RF communications equipment and the model TL 70 The model TL 70 is intended for use in electromagnetic environment in which radiated RF disturbances is controlled. The customer or the user of the model TL 70 can help prevent electromagnetic interference by...
Need help?
Do you have a question about the TL 70 and is the answer not in the manual?
Questions and answers