Installing The Batteries; Remote Control Operation - Precision VS11856 User Manual

Installing the Batteries

1. Open the battery cover in the direction shown.
2. Install batteries as indicated by the diagram inside the compartment.
3. Close the battery cover into position.
« »
NOTE
• Keep the batteries out of the reach of children. There is a danger of death by accidentally
swallowing the battery.
• Remove batteries from remote control when not being used for extended periods.
• Do not dispose of the used battery along with household waste. Dispose of used batteries
according to local regulations.
• Danger of explosion may occur if batteries are incorrectly replaced. Replace all the batteries
with new ones.

Remote Control Operation

Point the remote control at the infrared remote sensor and press a button.
• Operating the projector from the front
• Operating the projector from the rear
« »
NOTE
• Do not point the LED light pointer directly to the people's eyes (especially small children). There
is a danger of injury to the eyes.
• The remote control may not operate when there is sunlight or other strong light such as a
fluorescent lamp shining on the remote sensor.
• Operate the remote control from a position where the remote sensor is visible.
• Do not drop the remote control or jolt it.
• Keep the remote control out of locations with excessively high temperature or humidity.
• Do not get water on the remote control or place wet objects on it.
• Do not disassemble the remote control.
ENG