Bodet Harmonys Trio Installation And Operating Instructions Manual page 11

- Text:
Luminosity: Selection of the luminous intensity of the LED display from 1 to 4 (default
value: 3)
Time display: Selection of the time mode (HH:MM / HH:MM:SS / None). Note that when
the HH:MM:SS is selected the display will be in the 24H format.
Eco Mode: Used to enable the clock's energy-saving mode.
In Eco mode, the clock displays the flashing colon and is set to minimum brightness (level
1).
The Eco mode is applied to the time display only.
In the Eco mode the audio, text and flash remain active.
By default the Eco mode is disabled. When Eco mode is enabled its activation time can be
selected.
Scrolling speed: Selection of the scrolling speed of the scrolling message (Slow / Normal
/ Fast). By default the speed is set to Normal
- Flash
Luminosity: Selection of the luminous intensity of the flash (25%, 50%, 75% or 100%). by
default the intensity is set to 75%.
- Repeater
In a complex network with one or more remote installations it may be necessary to use
network gateways.
To do this, we must define repeaters that will move information from one network to another
in Unicast, a sounder being assigned as server repeater in one network and another as a
client repeater in the other network.
It is recommended to place the server repeater in an area where people are present.
NOTE: The repeater concept concerns only audio, flash and messages. For time
synchronisation the Harmonys Trio on the remote network must synchronise in NTP
Unicast in order to display the time (refer to the document 607729).
Repeater address: used to enter the network address of the other sounder of the repeater
pair.
The Save and Save and Reboot button saves your configuration and reboots the
equipment.
11