Important safety instructions When using your appliance, basic precautions should always be followed, including the following: • Read all instructions before using this appliance. • This appliance has been designed for indoor, domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.
Page 3
and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. •...
Page 4
reassembly or repair could cause a risk of fire, electrical shock or injury to persons when the appliance is used. • Close supervision is necessary for any appliance being used by or near children. • Before storing the appliance, once it is unplugged, please wait until it has cooled down (around 1 hour).
provided by the manufacturer is not recommended and may result in fire, electric shock or personal injury. • The appliance must be placed on a flat, stable, heat and water resistant surface. When placing the appliance on its base, ensure that the surface on which the base is placed is stable.
PRODUCT DESCRIPTION ON/OFF button + light indicator Cord exit Steam head Head unlocking button Steam button Fabric brush Water tank inlet cap Travel pouch Water tank Beaker 60ml * Depending on model...
BEFORE USE Always unfold the steam head until it is locked before any use of the appliance. Open the water inlet cap and fill the beaker with water up to the maximum limit. Fill the water tank with a maximum of 120 ml (2 beakers of 60ml) of untreated tap water (See section «what water to use»).
Page 9
As steam is very hot: never attempt to remove creases from a garment while it is being worn, always hang garments on a clothes hanger. ACCESSORIES The fabric brush opens the weaves of the fabrics for better steam penetration. Before removing or attaching the steam brush, unplug your appliance and allow it to cool down, for one hour.
Page 10
Plug-in the appliance. Switch on the appliance. Wait until the light stops flashing (approximately 15 seconds). When the light is steady the appliance is ready to use. Press the steam button with the steam head facing away from you holding it in a vertical position.
Page 11
For optimal use, pass the steam jets over your garment from top to bottom. Tips: Check the fabric’s label for recommendations. We recommended that you test acrylic, nylon or other synthetic fabrics in an inconspicuous area to ensure these fabrics are not damaged by hot steam. Warning : Never steam a garment while it is being worn.
AFTER USE Press and hold the On/Off button for 3 seconds to switch the appliance off. Unplug the appliance. Wait for an hour for your appliance to cool before storing.
Page 13
Empty the water tank completely and then close the water inlet cap. For storage purposes or to place in the travel pouch, it is possible to fold the appliance. Always press the head unlocking button before folding the head. Do not wind the powercord tightly around the appliance.
Page 14
ANTI CALC If you notice a decrease in the performance of your appliance, it may need descaling. Do this process in a well ventilated room. Fill the beaker with 50% untreated tap water and 50% white vinegar and pour into the Water water tank of the appliance.
Page 15
Wait until the light stops flashing (approximately 15 seconds). When the light is steady, release steam by pressing continuously on the steam button away from any garments. Allow the appliance to run until the water tank is completely emptied. Open the water tank inlet cap to fill it 100% with untreated tap water at maximum level and repeat the previous operation until the water tank is completely empty in order to...
Page 16
CLEANING Wait an hour for the appliance to completely cool down. Clean the plastic parts of the appliance with a dry cloth. Never wash or rinse appliance directly over a sink.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSES SOLUTIONS There is no steam. The appliance is not plugged in, or Check that your appliance is correctly not switched on. plugged in and switched on. Then wait approximatively 15 sec for steam to be available. The water level is too low.
Need help?
Do you have a question about the DT30 Series and is the answer not in the manual?
Questions and answers