Bosch AdvancedRotak 650 Original Instructions Manual page 12

OBJ_BUCH-3146-003.book Page 12 Monday, December 11, 2017 8:42 AM
12 | English
Use extreme caution when stepping

back or pulling the machine towards
you.
Never mow by pulling the mower to-

wards you.
Wait until the blades stop if the ma-

chine has to be tilted for transporta-
tion when crossing surfaces other
than grass and when transporting the
machine to and from the area to be
mowed.
Do not tilt the machine when starting

or switching on the motor.
Switch on the motor according to the

instructions with feet well away from
rotating parts.
Do not put hands or feet near or un-

der rotating parts.
Always stand clear of the discharge

zone when operating the machine.
Never pick up or carry the machine

while the motor is running.
Do not modify this product. Unau-

thorized modifications may impair
the safety of your product and may
result in increased noise and vibra-
tion.
Regularly inspect the supply cable

and any extension cables. Do not con-
nect damaged cables to the supply or
touch a damaged cable before it is
disconnected from the supply. A
damaged cable can lead to contact
with live parts. Beware electric shock
hazard.
Leaf Collect
The leaf collect blade has been de-
signed to allow you to pick up autumn
leaves from your lawn. In order for this
F 016 L81 572 | (11.12.17)
functionality to work within optimal pa-
rameters, please note the following:
– only collect leaves with the machine
set at 70 mm cutting hight
– collect leaves from your lawn only
– before collecting leaves inspect the
area where the machine is to be used
and keep people, pets, glass struc-
tures and cars away from use
Remove the plug from the socket:
– Whenever you leave the machine.
– before clearing a blockage,
– before checking, cleaning or working
on the machine,
– after striking a foreign object. Inspect
the machine for damage and make re-
pairs as necessary,
– if the machine starts to vibrate abnor-
mally (check immediately).
Connecting to the mains
The voltage indicated on the rating

plate must correspond to the voltage
of the power source.
We recommend that this equipment

is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
Only use or replace power supply ca-

bles for this unit which correspond to
the types indicated by the manufac-
turer. See the operating instructions
for the order no. and types.
Never touch the mains plug with wet

hands.
Do not run over, crush or pull the

power supply cord or extension cord,
otherwise it may be damaged. Pro-
Bosch Power Tools