Advertisement
Quick Links
MPD-300
WIRELESS PASSIVE
INFRARED DETECTOR
The MPD-300 detector can detect motion in a protected area. It can be used in conjunction with
the MICRA alarm module with firmware version 2.02 or newer. This manual applies to the
detector with electronics version 1.2 or newer.
1. Features
Dual element pyrosensor.
Digital motion detection algorithm.
Detector signal path self-diagnostic.
Pet immunity up to 15 kg.
Digital temperature compensation.
LED indicator.
Tamper protection in 2 ways – cover and/or detector removal.
2. Specifications
Operating frequency band...............................................................................433,05 ÷ 434,79 MHz
Radio communication range (in open area) ................................................................... up to 200 m
Battery ........................................................................................................................... CR123A 3 V
Battery life expectancy (energy save mode) ............................................................ approx. 3 years
Standby current consumption...................................................................................................90 µA
Maximum current consumption ............................................................................................... 20 mA
Detectable speed.............................................................................................................. 0,3...3 m/s
Environmental class according to EN50130-5 ................................................................................ II
Operating temperature range ....................................................................................-10 °C...+55 °C
Maximum humidity.................................................................................................................. 93±3%
Recommended installation height ............................................................................................ 2,4 m
Enclosure dimensions .............................................................................................63 x 96 x 49 mm
Weight ...................................................................................................................................... 108 g
Hereby, SATEL sp. z o.o., declares that this detector is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. The declaration of
3. Description
Motion detection or opening the tamper contact causes an alarm. Information on the alarm is
send by radio to the MICRA alarm module.
The detector can work in the following modes:
normal – each alarm results in sending a radio transmission.
energy save – after sending information about the alarm caused by motion detection, the next
transmission containing information on this alarm will be sent after 3 minutes at the earliest.
Tamper alarms are always sent.
®
conformity may be consulted at www.satel.eu/ce
mpd300_en 03/12
Advertisement
Summary of Contents for Satelco MPD-300
- Page 1 INFRARED DETECTOR mpd300_en 03/12 The MPD-300 detector can detect motion in a protected area. It can be used in conjunction with the MICRA alarm module with firmware version 2.02 or newer. This manual applies to the detector with electronics version 1.2 or newer.
- Page 2 MPD-300 SATEL test – the detector operates like in the normal mode, but the alarms are signaled by the LED (the LED is lit for 2 seconds). To select between normal mode and energy saving mode, use the E-SAVE MODE pins (Fig. 1).
- Page 3 SATEL MPD-300 4. Installation There is a danger of battery explosion when using a different battery than recommended by the manufacturer, or handling the battery improperly. Be particularly careful during installation and replacement of the battery. The manufacturer is not liable for the consequences of incorrect installation of the battery.
- Page 4 MPD-300 SATEL 6. Secure the back tamper unit directly to the wall (Fig. 6) or to the bracket screwed down to the wall or ceiling (Fig. 7). If the pet immunity option is enabled, the detector cannot be mounted on the bracket.