weed instrument EOTec 2000 Installation Instructions

Safety and Warning Information
Connect the DIN Rail via the End Clamp (2A09)
to protective earth ground with low impedance.
The modules are grounded to PE when they are
snapped onto the DIN Rail.
When in operation, do not look directly into the
transmit optical port or use magnification or
focusing equipment to view optical output.
IEC 60825-1, Class 1 LED Product
FDA 21 CFR 1040.10 & 1040.11
CAUTION: Use of controls and/or adjustments or
the performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
When used in Hazardous Locations:
Class I, Division 2, Groups A, B, C & D, T4.
Substitution of components may impair suitability
for Class I, Division 2. Power, input and output
(I/O) wiring must be in accordance with Class I,
Division 2 wiring methods and in accordance with
the authority having jurisdiction.
connect/disconnect equipment unless area is
known to be non-hazardous and power is
switched off. Certified components for use in a
suitable enclosure. The maximum ambient
temperature is 85° C.
Notice: The 2E46 module is not recommended
for use with the ControlNet protocol.
Important Notice - Before utilizing the product, the user should
determine the suitability of the product for its intended use.
The user assumes all risk and liability in connection with such
use. WEED INSTRUMENT'S WRITTEN WARRANTY FOR
THE PRODUCT IS MADE IN LIEU OF ALL OTHER
WARRANTIES, EXPRESSED OR IMPLIED WARRANTIES
OF MERCHANTABILITY
PARTICULAR PURPOSE. The user's exclusive remedy for
breach of Weed Instrument's written warranty shall be the
repair or replacement of such quantity of product which is
proven to be defective. In no case shall Weed Instrument be
liable for any special, incidental, or consequential damages
based upon breach of contract, negligence, strict liability or
other legal theory.
Weed Instrument Co., Inc.
Round Rock, Texas, USA
Do not
Further technical information can be obtained by
contacting Weed Instrument Co., Inc., Fiber
Optic Products Group.
Phone:
Fax:
Email:
Visit:
Publication Number:
AND FITNESS FOR A
800.880.9333
512.434.2850
512.434.2851
fiberop@weedinstrument.com
www.weedinstrument.com
RM0900082 Rev. 6/12
Fiber Optics
2E46
EOTec 2000 Optical Module
Installation Instructions
For use with Single-Mode Fiber
ST* Compatible Fiber Connections
1300nm Optical Wavelength
High Optical Power Output
Data Rates from 9.6k to 12Mbps