Advertisement
SETTING UP THE PS XPANDER 100
Before using the PowerStage Xpander
100, please read and follow the steps
listed below:
1. Heed all safety warnings when
operating the PowerStage Xpander 100.
2. Make sure the power switch is in the OFF position.
3. Plug the female end of the supply cord into the
supply cord jack (item B previous page) of the
PowerStage Xpander 100. Next, plug the supply
cord into a power source with the correct voltage.
4. Connect the cord from the PowerStage 100's line
output jack to the line input jack of the PowerStage
Xpander 100.
5. First turn the PowerStage Xpander 100 ON, then the
PowerStage 100.
6. Adjust volume levels on the PowerStage 100 to
the appropriate levels, listening for feedback or other
ringing.
7. If feedback is encountered, rotate the appropriate
(
or
band) frequency notch filter control on
LOW
HIGH
the PowerStage 100 down to its lowest position.
Next, slowly turn the frequency control knob to
pinpoint the location of the problem frequency and
cancel it.
8. Steps 6 and 7 may need to be performed more
than once if several feedback problems occur.
CARPET COVERING CARE
The PowerStage Xpander 100 is covered
in a tough, soil resistant synthetic
indoor/outdoor carpet for long life and
lasting good looks.
carpeted cabinet, use a brush to wipe
away any smudges or dirt. For stubborn stains, a
sponge with a light soapy solution may be used.
Avoid spilling liquids on the operating surface, heat
sink, grille, volume and tone controls, switches and
speakers. ALWAYS unplug the PowerStage Xpander
100 before cleaning it and wait until it has dried
before plugging in the PowerStage Xpander 100.
GROUNDING AND HUMS
circuits. Also, if the audio wiring is placed too close
to the power cords, hums or buzzes can also bleed
into the system. Still, improperly maintained power
and audio cables are yet another cause of
bothersome noise. In order to help minimize stray
hums and buzzes, here are some helpful hints.
1. Keep all electronics connected to the sound
system on the same electrical circuit.
2. Keep audio signals cables away from the AC
power cords.
3. Use balanced cables when applicable.
4. Always plug the PowerStage Xpander 100 into a
grounded AC electrical outlet.
5. Be sure to use properly maintained cords and
cables with the PowerStage Xpander 100.
TROUBLESHOOTING
• Is the PowerStage Xpander 100 power cord
properly plugged into an electrical outlet?
• Is the power cord properly plugged into the
PowerStage Xpander 100's supply cord jack?
To clean the
• Is there power at the outlet?
• Does PowerStage 100 have power?
• Are the volume control knobs on the Power
Stage 100 turned above the
• Is the Power Stage 100 properly plugged into the
PowerStage Xpander 100?
• Is the mic/instrument turned on?
• Are your audio cables frayed, cut or damaged?
If after checking all of the above the PowerStage
Xpander 100 is still not performing correctly, consult
your authorized Fender Service Center.
Ground loops are probably the most
common cause of hum and buzz in
sound reinforcement systems and other
audio products. A ground loop usually
occurs if the separate pieces of
equipment are plugged into different AC
If the PowerStage 100 is set up but
does not function, please check the
following items:
position?
MIN
Advertisement
