EP30006
10.15.5. Removing the Width motor
1.
Disconnect the Connector (CN501) on the Main PCB.
2.
Cut the Insulated ties bundling Lead wires.
3.
Remove the Width belt.
4.
Unscrew four Screws on the Width motor.
10.15.6. Removing the Pinching air bag
1.
Remove the Massage mechanism block from the Rear frame.
2.
Remove the PCB install plate.
3.
Remove the Pin.
4.
Remove the Rivet.
5.
Remove two Hex screws, then you can remove the Pinching air bag.
Caution in installing
Be careful of the directions of install of the Hose clamp and the Snap pin.
- 41 -
ORDER NO.HPD0706U16C1