KTM 25 EXC 2016 Setup Instructions page 8

2 SETUP
(All EXC models)
–
Position the controls on the left half of the handlebar.
V00040-01
(XC-W, 300 XC‑W Six Days US)
–
Position the controls on the left half of the handlebar.
V00041-01
(All EXC models)
–
Remove the fuel tank. (
–
Disconnect the plug-in connector on the main wiring harness.
–
Connect the plug-in connector of the turn signal wiring harness with the plug-in
connector of the main wiring harness.
–
Position the turn signal wiring harness against the main wiring harness and
secure with cable ties.
–
Install the fuel tank. (
–
Position the turn signal indicator lamp in the speedometer holder.
B01750-01
–
Insert the black and violet cables of bulb included in the separate enclosure
into the socket and position it in the turn signal indicator lamp.
–
Secure turn signal relay
–
Position the turn signal on each side and mount and tighten nuts
–
Connect the plug-in connector
marked green on the wiring harness.
–
Connect plug-in connector
red on the wiring harness.
B02188-10
(All EXC models)
–
Mount the turn signal switch and connect the plug-in connector on the wiring
harness.
402148-01
Info
The figure shows how to route the clutch line and wiring harness.
Info
The figure shows how to route the clutch line and wiring harness.
p. 10)
p. 11)
 with a cable tie and plug in the connector.


of the left turn signal with the connector marked
of the right turn signal with the connector
6

.