Advertisement
Installation
The product must be installed and maintained by a
building/construction and/or electrical regulations and
relevant legislation.
Warning: Switch off mains electrical supply prior to
installing and connecting the luminaire.
Notice:
than the original manufacturer, then the warranty will
no longer be valid and shall become the full respon-
sibility of the modifying person/organisation. Claims
based on defects attributable to improper installation
and/or application, and the consequences thereof, are
excluded.
Installation Procedure
1) Switch off the mains electrical supply.
2) Remove cover A by releasing screws B.
3) Check that rating shown on luminaire label
conforms with mains electrical supply.
relevant holes D and insert wall plugs E.
Warning: Ensure not to damage any electric cable,
water pipe or other devices while drilling holes.
5) Feed the mains supply cable F (and the second
cable G for through wiring, if required) through the
grommets H at the bottom of the housing, while
luminaire, pierce through the nylon plug N with
screws C, and tighten (Fig. I).
Attention: The nylon plugs N must remain in
position to provide sealing.
6) Connect mains supply leads to respective terminals
in terminal block I:
a) ON/OFF (L = Phase, N = Neutral,
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
7) Reposition the cover A and secure in position by
evenly tightening the screws B.
3
C. Drill
= Earthing)
Advertisement
