Tools Required; Safe Handling Guidelines - GE T2100 Service Manual

Tools Required

Safe Handling Guidelines

Revision A
Installation: Tools Required
To install the GE T2100 Treadmill, you will need the following tools:
Multi-meter
!
Standard hand-tools
!
T-bar allen wrench (included with GE T2100 Treadmill)
!
Carpenter's level
!
15 mm (9/16") socket wrench
!
NOTE
See "Required Tools and Supplies"
tools required for maintenance of the GE T2100 Treadmill.
The GE T2100 Treadmill ships preset with an approximate 2% grade.
This slight elevation provides for free wheel movement and prevents the
shroud from scraping the floor.
If you are moving the GE T2100 Treadmill after it has been in operation,
use the controlling equipment to set the grade to approximately 7%.
Then remove power and disconnect all cables to the GE T2100 Treadmill
before moving the unit.
NOTE
We recommend the GE T2100 Treadmill not be placed on carpet or
carpet tile floors as a final location, as continual movement of the
wheels may eventually damage the carpet and possibly the GE
T2100 Treadmill.
WARNING
INJURY OR DAMAGE – The GE T2100 Treadmill is too
heavy to lift, lower or move safely by one person. Serious
bodily injury or damage to the GE T2100 Treadmill may
result.
A minimum of two people are required when lifting,
lowering or moving the GE T2100 Treadmill.
1. Lift the end of the bed assembly to about knee height, keeping knees
bent and back straight as you lift.
2. Rotate the GE T2100 Treadmill in the direction you want to go (the
GE T2100 Treadmill will pivot on its wheels) and push forward.
GE T2100 Treadmill
2021403-031
on page 7-3 for a complete list of
3-3