Field Replaceable Units - GE T2100 Service Manual

Ordering Parts

Field Replaceable Units

Revision A
Ordering Parts: Ordering Parts
Below is a table identifying the field replaceable units (FRUs) and their
part numbers.
NOTE
The drive motor, sprocket, and flywheel should be ordered together
whenever replacing either of these FRUs. They are fitted with tight
machined tolerances and may be difficult to disassemble.
GE Part Number
2023710-001 Drive Motor (see note above)
2023254-001 Sprocket (see note above)
2023253-001 Flywheel (see note above)
2026182-002 Drive Controller w/ firmware (Exchangeable)
88380-007 Emergency Stop Switch (ESTOP)
700338-002 Harness, Elevation Limit Switch
2023887-001 Braking Resistor & Harness
2023446-001 Communication Harness Processor to Drive Controller
2023442-001 24Volt Distribution Harness
2026180-001 Shroud w/ T2100 label (front)
2026390-001 Shroud Cover w/ service label (rear)
2022341-001 Power PCB (located in the e-box)
2021939-001 Processor PCB/Service & Host I/F PCB (located in the e-box)
2026599-001 Power Supply (located in the e-box)
2023445-001 Power PCB to 24V Power Supply Harness (located in the e-box)
2023441-001 Ribbon Cable from Power PCB to Processor PCB (located in the
e-box)
2024974-001 Power to Processor PCB Harness (located in the e-box)
2024413-001 Elevation Cap Harness (located in the e-box)
2024412-001 Filter to Power PCB Harness (located in the e-box)
2015553-001 EMI Filter (located in the e-box)
408934-001 Switch to Filter Harness (located in the e-box)
GE T2100 Treadmill
2021403-031
Description
8-3