1-3 Power Spec. - Input Power : 8VDC ~ 24VDC - Consumption Power : 12Watt, Max 1-4 Switch Input mode - Possible to switch input mode through original button 2. Features Easy installation with plug & play power/LVDS cable GU Electronic...
Specification 3. Diagram INTERFACE COMMAND EEPROM SYSTEM RECEIVER LVDS LVDS LVDS Scaler NAVIGATION LVDS RELAY (PIP) SYSTEM CVBS1 CVBS2 COMPOSITE FRONT CAMERA REAR CAMERA REAR CAMERA POWER TFT-LCD LVDS GU Electronic...
Specification 4. Components LVDS Cable 1 EA LVDS Extension Cable 1 EA OSD Board 1 EA Sub Board 1 EA A/V Cable 1 EA Power Cable 1 EA RGB NAVI Cable 1EA GU Electronic...
③ B DATA (Blue) ③ FRONT PWR (Red) ④ SYNC (White) ④ CAN-H (Orange) ⑤ GND (Black) ⑤ CAN-L (Green) ⑥ DVB-T IR (Green) ⑥ FRONT DET (Blue) ⑦ DVD IR (Orange) ⑦ REAR DET (Brown) ⑧ GND (Black) GU Electronic...
ON : Skipping NAVI NAVI OFF : Display ON : Skipping DVB-T(AV1) DVB-T(AV1) OFF : Display ON : Skipping DVD(AV2) DVD(AV2) OFF : Display OFF : AUDI R8 Car model OFF : AUDI R8 * Example AUDI R8 GU Electronic...
Settings 2. Original button - Switching mode Long Press: Switching mode Short Press: Switching to OEM directly NAVI ※ You can activate the button on Steering wheel in OSD Menu (P.11) GU Electronic...
※ Press “MENU” button on Key board Config - NAVI-RGB : Setup for the type of NAVI-RGB Config - DVB-T(DMB) : Setup for the type of DVB-T(DMB) Config - DVD : Setup for the type of DVD Reset : Reset all value GU Electronic...
Page 10
OFF - Power OFF RearCam-Det : Setup for Rear detection • CAN : By CAN(Gear) Extwire : by rear cam detect wire • AV Mode(NC) FrontCam-Type : Setup for front camera • ExtDevice - External rear camera OEM - Original camera GU Electronic...
Page 11
RGB, DVD, OEM from Rear NAVI NAVI REAR FRONT AV1(DVB-T) AV1(DVB-T) Select time of display AV2(DVD) AV2(DVD) 1~30 second SteeringMode : Setting Handle wheel button - ON or OFF • Reset : Reset all value • GU Electronic...
Page 12
Settings 4. OSD Menu ※ Press “MENU” button on Key board - NAVI(RGB) Image / Screen - DVD, DVBT, NAVI-AV, REAR, FRONT Image GU Electronic...
Page 13
- Adjust the position of Parking guide line Possible to adjust the position of line by Keypad in Horizontal / Vertical menu ※ Pressing this Horizontal / Vertical menu, The OSD screen automatically disappears. Please adjust from the parking line Screen. Left Right Down GU Electronic...
Page 14
OSD – Display : Setting time for displaying OSD menu • OSD – Transparency • OSD – Language : Setting language of ODS menu • - Utility MENU Utility Factory Reset Execute Cancel Utility Version AURR20KRX - 170303 Utilityy– INTERFACE SOFTWARE • GU Electronic...
① Take the monitor system off the picture above from a car ③ Disconnect the indicated ④ Remove the indicated black cover FPC cable as the picture above Caution!! FPC should be 31Pin (Less than 31pin – Analog monitor) GU Electronic...
LVDS Extension cable into the indicated hole as the picture above →Provided LVDS cable → Provided Sub Board → OEM FPC Cable ② Please pull the provided LVDS to connect to the Sub board as shown in the picture GU Electronic...
LVDS cable must be connected correctly according to the manual • Insulate the end of wire by using electrical tape • The installation should be done by expert • GU electronic does not take any responsibility for any problem • caused by wrong installation...
Need help?
Do you have a question about the AUDI R PAS D and is the answer not in the manual?
Questions and answers