Cisco Firepower 2100 Getting Started Manual page 110

Configure Licensing
You can optionally check the Force registration check box to register an ASA that is already registered, but
that might be out of sync with the License Authority. For example, use Force registration if the ASA was
accidentally removed from the Smart Software Manager.
Step 6 Click Register.
The ASA registers with the License Authority using the pre-configured outside interface, and requests
authorization for the configured license entitlements. The License Authority also applies the Strong Encryption
(3DES/AES) license if your account allows. ASDM refreshes the page when the license status is updated.
You can also choose Monitoring > Properties > Smart License to check the license status, particularly if
the registration fails.
Step 7 Set the following parameters:
a) Check Enable Smart license configuration.
b) From the Feature Tier drop-down list, choose Standard.
Only the Standard tier is available.
c) (Optional) For the Context license, enter the number of contexts.
You can use 2 contexts without a license. The maximum number of contexts depends on your model:
• Firepower 2110—25 contexts
• Firepower 2120—25 contexts
• Firepower 2130—30 contexts
• Firepower 2140—40 contexts
For example, to use the maximum of 25 contexts on the Firepower 2110, enter 23 for the number of
contexts; this value is added to the default of 2.
Cisco Firepower 2100 Getting Started Guide
108
ASA Appliance Mode Deployment with ASDM