Table of Contents
Advertisement
Unlock the Packaging Locks
1. Rotate the packaging lock 90 degrees counterclockwise.
2. Pull out the packaging lock and discard.
1. Turn the packaging lock counterclockwise several times.
2. Pull out the packaging lock and discard.
WARNING
Do not insert anything other than the included SCREWS
or NAILS into the TRAY HOLES of the ELECTRONIC
PROJECT TRAY. Doing so may damage the ELECTRONIC
PROJECT TRAY.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom
of the unit, use a screwdriver to loosen the
screw and open the battery cover.
3. Remove old batteries by pulling up on one
end of each battery.
4. Install 2 new AA batteries following the
diagram inside the battery box.
5. Replace the battery cover and tighten the screw to secure.
4
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Drill & Learn Toolbox Deluxe and is the answer not in the manual?
Questions and answers