Husqvarna TS70 Operator's Manual page 9

General
Place the tile saw on a flat, horizontal and stable surface
to prevent the equipment from tipping over, sliding or
walking on the surface.
Assemble the stand
• Screw together the stand and saw frame with 4
screws.
CAUTION! Make sure the stand is
!
fastened securely.
• Assemble the side board.
Level the saw
CAUTION! The machine must be placed on a level
surface to ensure the correct function of the water
system circuit.
• Use the spirit level to determine whether the machine
is standing sufficiently level.
ASSEMBLING AND ADJUSTMENTS
Adjust the working height
Adjustable stand
• Loosen the catch on the side of the rear handle on the
stand and pull the stand up to the working height.
• The hand can be set to a number of fixed heights.
Loosen the catch for one of the fixed heights by
pressing the catch on the rear handle while pulling/
lifting the handle.
• On uneven surfaces, the feet on the stand can be
adjusted individually. The stand foot is adjusted either
by pressing on the foot while lifting up the saw with the
rear handle or by loosening the catch on the foot.
Fixed stand
• Position the machine on flat ground. Adjust the frame
legs and use shimming material if needed to level the
machine.
The machine can also be used without frame legs or
placed on a workbench.
–
English 9