Advertisement
Available languages
Available languages
Angle settings
90° ° ° °
•
Loosen the lock knob for the mitre (1).
•
Loosen the lock nut (2). Adjust the cutting arm so that
the lock knob for the mitre is at its lower end position
in the guide. Adjust the screw (3) so it bottoms on the
support arm.
3
•
Tighten the locking nut.
45° ° ° °
•
Loosen the locking knob for depth setting and raise up
the cutting arm.
•
Loosen the lock knob for the mitre (1). Angle the
cutting arm until the screw (2) bottoms at the guide
end plate.
2
•
Check the angle, 45° and if needed loosen the lock
nut and adjust the screw (2) until it bottoms at the
guide end plate.
2
ASSEMBLING AND ADJUSTMENTS
1
2
1
45
22,5° ° ° °
•
Loosen the locking knob for depth setting and raise up
the cutting arm.
•
Loosen the lock knob for the mitre (1). Angle the
cutting arm until the markings for 22,5° are opposite
each other (2).
•
Check the angle, 22,5° and if needed adjust the
triangular shaped marking (2).
2
1
Parallel to the cutting slot and
centered in the cutting slot
•
Set the blade to run freely and in its lowest position in
the cutting slot.
•
Use an set square and check if the blade is
perpendicular, both front and back edge of the blade
to the conveyor cart anvil and check if the blade is
centered in the cutting slot.
2
1
22,5
67,5
English
–
11
Advertisement
