Related Manuals for ClearSpan Premium Solar Star 104918
Summary of Contents for ClearSpan Premium Solar Star 104918
- Page 1 Premium Solar Star™ Home-Attached Greenhouse Assembly Instructions SKU# 104918 ©2006 ClearSpan™ All rights reserved. Reproduction without permission is prohibited. Revision date: April 2006g...
- Page 2 Consult a professional contractor to determine the best must seek the help of a qualified contractor. and safest way to anchor the greenhouse. Visit www.ClearSpan.com for additional products and customer assistance. 1 of 16...
-
Page 3: Assembly Procedure
Adjustable pliers and self-locking pliers • Ladders and/or work platforms • Adjustable Clamps to clamp panels together during installation. Additional tools and supports may be needed depending on the structure, location, and application. Visit www.ClearSpan.com for additional products and customer assistance. 2 of 16... - Page 4 Metal Frame Recycled Plastic Base A-Angle (104642) to secure steel Neo-Bonded washers Roof Support Plates frame to recycled plastic base and Tek Screws (if recycled plastic base is used). Visit www.ClearSpan.com for additional products and customer assistance. 3 of 16...
- Page 5 NOTE: Do not seat the plain pipe tightly to the swaged Front Board pipe. The separate pipes must be allowed to adjust outward during assembly to allow proper panel fit. Visit www.ClearSpan.com for additional products and customer assistance. 4 of 16...
- Page 6 NOTE: All 3" x 3" square plates are attached to the polycarbonate to the outside and the frame to the inside. greenhouse on the inside using self-tapping screws. See the photo that follows. Visit www.ClearSpan.com for additional products and customer assistance. 5 of 16...
- Page 7 NOTE: The raised portion of the pass-through connector is positioned to the inside of the greenhouse. DO NOT SECURE ANY PASS-THROUGH CONNECTORS TO THE METAL BASE FRAME AT THIS TIME. Visit www.ClearSpan.com for additional products and customer assistance. 6 of 16...
- Page 8 18. Take the remaining upper, angled end panel, loosen 104640 the screws, used to secure the polycarbonate along the bottom of the panel, and set the panel in position. View shows the inside of the greenhouse. Visit www.ClearSpan.com for additional products and customer assistance. 7 of 16...
- Page 9 It is used to show the panel location only. Installation is the same for your greenhouse if it differs in design. View is from the top looking down on the frame. Visit www.ClearSpan.com for additional products and customer assistance. 8 of 16...
- Page 10 24. Choose two (2) forty-eight inch (48") roof support plates, attach these to the tops of the short front panels, and work toward the other end of the greenhouse. Visit www.ClearSpan.com for additional products and customer assistance. 9 of 16...
- Page 11 30. Install the remaining long roof panel and secure it as previously described. 28. Secure the roof panels to the end panels using Tek screws and 3" x 3" flat plates installed earlier. Visit www.ClearSpan.com for additional products and customer assistance. 10 of 16...
- Page 12 NOTE: The upper roof support plates are attached in the same manner as the lower roof plates and in the same pattern, beginning with a short section and ending with a short section. Visit www.ClearSpan.com for additional products and customer assistance. 11 of 16...
- Page 13 Install two (2) openers for the vented roof panel. 40. After installing the vent openers, read the Foil Tape and Silicone Sealant information and attach the greenhouse flashing as described. Visit www.ClearSpan.com for additional products and customer assistance. 12 of 16...
- Page 14 WARNING: FLASHING IS SHARP! WEAR GLOVES WHEN HANDLING AND INSTALLING ALL FLASHING. Flashing White dashed line shows the edge of the flashing under the polycarbonate of the roof panel. Visit www.ClearSpan.com for additional products and customer assistance. 13 of 16...
- Page 15 4. Remove any sharp corners or edges that are present to prevent injury. 3. After attaching the first section, install the next section and overlap the first section by a few inches. Visit www.ClearSpan.com for additional products and customer assistance. 14 of 16...
- Page 16 CONSULT THE MUST READ DOCUMENT FOR with the shelter and must be purchased separately. ADDITIONAL ANCHORING INFORMATION. Contact Customer Service at 1-800-245-9881 to purchase additional parts to anchor the shelter. Visit www.ClearSpan.com for additional products and customer assistance. 15 of 16...
- Page 17 • If the shelter is moved, inspect all parts and connections before reassembling. • Depending on the contents, construction of the shelter, shelter materials, and shelter location, the potential for condensation exists. ClearSpan™ offers several items that can be used to help resolve a condensation condition. Please contact a ClearSpan™ representative for additional information.
Need help?
Do you have a question about the Premium Solar Star 104918 and is the answer not in the manual?
Questions and answers