Clas Ohlson BL-USB-2A Instruction Manual

USB 5-port PCI Card
Art. no. 38-2630 • Model BL-USB-2A
Please read the entire instruction manual before using and save it for future use. We apologise for
any text or photo errors and any changes of technical data. If you have any questions concerning
technical problems please contact our Customer Service Department.
Safety
- Notice! When installing a PCI card in an
available PCI slot it is very important that
the computer is turned off and that the
power cable is unplugged.
- Computer components are very sensitive
to static electricity. Use therefore an
antistatic wrist strap or similar product
when mounting or handling the card.
- If you do not have an antistatic wrist
strap, divert your own static electricity by
touching the computer chassis before and
while you handle the card.
- The card should be inserted evenly into the
PCI slot for correct mounting.
- Secure the card to the chassis with screws
or other locking mechanism.
Product description
USB 2.0 5-port PCI Card
-
Data transfer rate up to 480 Mbps
-
5x USB 2.0 ports (4 external, 1 internal)
-
Compatible with USB 2.0 and 1.1
-
Requires Windows 98SE or later
-
A USB allows you to connect peripherals
without turning off your computer, easily
with Plug and Play. It allows for rapid and
easy data transfer and is supported by
Win98SE, WinME, WinXP and Win2000.
Installation
The following installation instructions applies
to Windows XP with Service Pack 2 and may
vary depending on the computer configura-
tion.
1. Make sure the computer is turned off and
power cable unplugged.
2. Mount the USB card in an available PCI
slot.
3. Start the computer.
4. Drivers will now automatically be installed
by the operating system.
GREAT BRITAIN For consumer contact, please visit www.clasohlson.
co.uk and click on customer service.
ENGLISH
5. Verify that drivers have been installed by
going to "Device manager" (Start\Control
Panel\System\Hardware\Device Manager\
USB Controllers). If the drivers have
been correctly installed then this should
be indicated by "VIA Rev 5 or later USB
Universal Host Controller".
Notice!
-
USB 2.0 is only supported by Windows XP
with at least Service Pack 1 or Windows
2000 with at least service pack 4 installed.
-
If the Service Pack is not installed, or
Win98SE/ME is used, then the data
transfer rate is reduced to that of USB 1.1.
Disposal
Follow local ordinances when disposing of this
product. If you are unsure about how to dis-
pose of this product contact your municipality.