Changing The Jigging Sieve - Redexim Verti-Top 1200 User Manual And Parts Book

13.2 CHANGING THE JIGGING SIEVE

The Verti-Top is standard equipped with a jigging sieve that has a mesh of 5mm x 5mm.
Different circumstances may require sieves with a different mesh.
Changing the sieve is done as follows:
!! Make sure that the Verti-Top is blocked well and cannot move on its
own accord !!
!! Make sure that the PTO axle is detached from the Verti-Top !!
1. Open the hatch and remove the receptacles.
2. Turn the clips a quarter of a turn. This will allow the sieve to slide out of the machine.
3. Change the sieve and close the clips.
4. Return the receptacles and close the hatch.
Optionally, there are several types of sieves available:
- 3.2mm x 3.2mm
- 4mm x 4mm
- 5mm x 5mm
- 5.5mm x 5.5mm
- 6mm x 6mm
Please refer to the spare parts manual for the article numbers.
Shown version: VT 1200 (The same principle applies to the VT 1800.)
(0.13" x 0.13")
(0.16" x 0.16")
(0.2" x 0.2")
(0.22" x 0.22")
(0.24" x 0.24")
Figure 17
23