Table of Contents
Advertisement
6.2
ADJUSTING THE WORKING DEPTH OF THE REAR BRUSH
The working depth of the brush at the rear of the machine can be adjusted by sliding the
fastening plate at the side of the machine up or down,
The start procedure is as follows:
!! Make sure that the tractor / Verti-Top is blocked well and cannot move
on its own accord !!
!! Switch off the tractor before descending !!
1.
At both sides of the machine, unscrew the bolts
A set of keys is supplied with the machine; these are located in the
toolbox
2.
At both sides of the machine, adjust the brush at the same height. For this
purpose, use the indication stickers
3.
Screw the bolts on both sides of the machine tight.
NEVER adjust the machine in such a way that it could damage the subsoil.
First check the working depth on the subsoil statically before using the machine!
Shown version: VT 1200 (The same principle applies to the VT 1800.)
.
(Figure 13, C)
! IMPORTANT !
(Figure 13, A)
.
(Figure 13, B)
Figure 13
a few turns.
16
Advertisement
Table of Contents
