Adjusting The Working Depth Of Rake - Redexim Verti-Top 1200 User Manual And Parts Book

6.1

ADJUSTING THE WORKING DEPTH OF RAKE

The working depth of the rake can be adjusted by turning the spindles at the front side of the
machine.
The start procedure is as follows:
!! Make sure that the tractor / Verti-Top is blocked well and cannot move
on its own accord !!
!! Switch off the tractor before descending !!
1. Turn the spindles until the correct height is achieved
2. At both sides of the machine, adjust the rake at the same
height. For this purpose, use the indication stickers
NEVER adjust the machine in such a way that it could damage the subsoil.
First check the working depth on the subsoil statically before using the machine!
Shown version: VT 1200 (The same principle applies to the VT 1800.)
! IMPORTANT !
Figure 12
.
(Figure 12, A)
.
(Figure 12, B)
15