Table of Contents
Advertisement
Quick Links
RECYCLED MATERIAL
PICNIC TABLE
FLAT PACK
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE
Please also refer to the 'Manual Handling Operations Regulations 1992' during the handling of the
product and materials used for installation. Glasdon recommends that a full Health and Safety analysis
is carried out prior to installation.
1 of 8
Advertisement
Table of Contents
Related Manuals for Glasdon RECYCLED MATERIAL PICNIC TABLE
Summary of Contents for Glasdon RECYCLED MATERIAL PICNIC TABLE
- Page 1 IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE Please also refer to the ‘Manual Handling Operations Regulations 1992’ during the handling of the product and materials used for installation. Glasdon recommends that a full Health and Safety analysis is carried out prior to installation.
- Page 2 KIT CONTENTS: EQUIPMENT REQUIRED: ITEM 1 - M10 x 140mm Carriage Bolt x 10 - 17mm Socket ITEM 2 - Central Support Beam - Socket Driver ITEM 3 - Table Top Assembly - Socket Extension ITEM 4 - Angled Support Beam - Lump Hammer / Nylon Faced Hammer x 1 ITEM 5 - M10 x 150mm Carriage Bolt ITEM 6 - M10 Washer...
- Page 3 ASSEMBLY INSTRUCTIONS STEP 1 STEP 1 Fit Item 1 through the holes in Item 2 as shown. Hammer the fixing firmly into place so that the square neck of the fixing bites into the Enviropol . You will need to do this for each fixing ®...
- Page 4 STEP 4 Place Item 9 onto the assembled support frame as shown. Slot the cross bar onto the exposed fixings protruding from Item 2 (fitted during STEP 1). Use the hammer if necessary. Place Item 6 and thread Item 7 onto the fixing thread. Tighten the nut by hand. Repeat for the second fixing. Tighten both fixings with the socket driver.
- Page 5 STEP 5 Place Item 10 against the inside of the assembled Support Frame as shown. STEP 6 Hammer 2 x Item 11 into the 2 fixing holes in the assembled Support Frame (near to the Table Top) and through the corresponding fixing holes in the Legs. Place Item 6 and thread Item 7 onto the threads of the fixings.
- Page 6 STEP 8 Hammer 4 x Item 1 into the 4 x fixing holes in both Item 12’s. You may find it helpful to temporarily rest the Seat Pan on to 2 x Item 13’s to raise the assembly off the ground sufficiently to allow the bolts to be hammered through.
- Page 7 STEP 10 Place 4 x Item 13 under the Seat Legs as shown. Fix the Leg Supports in place by hammering Item 11 through the Support Cross Bar and through the Leg Supports. Place Item 6 and thread Item 7 onto the exposed fixing thread. Tighten the nut by hand. Repeat for the remaining 3 x Leg Supports.
- Page 8 Fax : 01253 792558 Stock No. C000/0506 - DWG No. 09B-022-49 Issue 1 - August 2017 e-mail: sales@glasdon-uk.co.uk © Copyright AUG 2017 web: www.glasdon.com Glasdon UK Ltd reserve the right to alter specifications without prior notice. 8 of 8...
Need help?
Do you have a question about the RECYCLED MATERIAL PICNIC TABLE and is the answer not in the manual?
Questions and answers